Since my 2.2 update last week, my wifi doesn't seem to work. It recognizes the SSID, connects, but I have no internet. The status bar shows that it is connected, but data wont load. Everything else that runs on wireless in my house works fine. Is anyone else having this problem or would anyone have a solution to this?
View 7 Replies
I got my htc desire about a month ago and it was no bother connecting it to the internet...worked great....then a few days ago i dropped my phone in a puddle top first and it covered 3 quarters of my phone i dried it off best i could and it work straight away then went all funny and the touch screen wouldnt even work ...but now after leaving it for a few days its fine works all the same apart from the wifi whenever i try to connect to it it says turning on then 30 seconds later error! yet if i connect to my mobile network internet it works.
View 1 Replies View RelatedI am trying to get a profile setup for my wifi but that doesnt seems to work very correctly
Here is what i did
Cell near<scanned cells near my house> ---> wifi set on
Wifi near<my SSId>
<-- wifi set off
Now i did this thinking if in my area using scanned cells plus in range of my wifi----> it should turn on
And if the above criteria doesnt match then it should go off
Please advise if i am doing it wrong
I was also thinking when i reach back home phone should say welcome home or something ( was trying just for fun) but that doesnt work properly either i was using it with my wifi profile but the it keeps on reading the message few times i was thinking everytime phone changes the cell it reads the message to me.
Did the Moment 2.1 Update and installed the old HTC Keyboard and it doesnt work. Is there an updated version for the 2.1 moment?
View 4 Replies View RelatedI have the camera open and I long touch an object and the little box turns green and it makes a noise but no picture is taken...how can i make it take the picture using a long touch
View 13 Replies View Relatedwireless tether and barnacle wifi tether doesnt work after 2.2 leak.
View 4 Replies View RelatedI now have "Low on Space" and "Not enough storage space for SM (then it's cutoff)". I have done 6 factory resets since getting it and after the last two I have added no apps to it. I have plenty of memory left but the message still pops up and GMAIL sent and Trash is empty, I have 29mb in use out of 7486mb in Gmail in use and i am about to walk into a Verizon store and beat someone senseless with this piece of crap phone. The INC is the only Android+Sense phone doing this right? Now my Bluetooth wont turn on or off. The widget and menu+settings doesn't work.
View 5 Replies View RelatedUpdated to 4.2 yesterday which is great.
But, on one of my panels I have a Calendar widget showing my future appointments. Since the update it only shows one week ahead where as before it showed about 2 months.
Is there a way to get it to show 2 months again?
Facebook chat doesnt seem to work on any app. It always comes up with the wrong username/password etc... even when its right. I have tried imeem and ebuddy and none work.
View 3 Replies View RelatedI just brought a calander plugin for locale and it force closes Is there a way to get a refund on a app that doesnt work?
View 4 Replies View RelatedI follow the instructions exactly on this page (and some of the other tutorials) but they always seem to be missing some key information as they dont work out of the box
I added a bunch of packages that seemed like were missing, but now I'm stuck.
http://developer.android.com/resources/tutorials/views/hello-gridview.html
Description Resource Path Location Type Conversion to Dalvik format failed with error 1 HelloGrid Unknown Android Packaging Problem
And a whole bunch of these for each of the drawable.sample_* references
Description Resource Path Location Type R.drawable.sample_0 cannot be resolved ImageAdapter.java /HelloGrid/src/com/example/ImageAdapter line 51 Java Problem
CODE:....
As you can see I have all the images loaded in the /drawable directory
i bought the evo a few weeks after it came out and its always had a problem with the power button. i was told that it would be replaced but at the time the evo was at such a high demand i had to wait. so in that time the button worked great and i forgot about it. well no its to the point that i cant even get it out of standby without using the usb cable. and i don't have the 30 days on it anymore or insurance..
View 1 Replies View RelatedI have some media (Audio tracks) on an app.With file path 'R.raw.test'.I use some code to get it into a mediaplayer: MediaPlayer.create(Textbox.this, R.raw.fly);
And it works PERFECTLY on the Android Emulator...(Plays track on click of button)Can someone explain why, when I put it on my Archos (5 IT) it doesnt work at all? As soon as the button is clicked, it crashes.Do you have to do something to file paths or what?
Does anyone know how to get the texts for events to appear in the Calendar week view? It has a picture of it in the manual but nothing about how to do it. My Incred currently just shoes the color of the event (red for business etc) and I want to see what the events are! I have tried experimenting with the length of the title and that makes no difference. Any thoughts?
View 9 Replies View RelatedI go to sleep with the phone next to me at 70% battery life, wake-up 2 hours later and the phones dead. This has happend twice now, before this battery life hasent been an issue.
I've used the phone for about a weeks and everything was great, until two days ago (not sure what happend, I did install a 16gb SDHC card).
If the 16gb SDHC card is whats causing the battery life to be good for ~2 hours unplugged with 0 usage, then this is useless..
The GPS is off, WiFi is off, signal strength is about -85dB.
Facebook is set to every 3 hours
Weather Every 6 Hours
Exchange is set to push with a 10kb attachment limit (doesnt seem to even work).
For an example I just charged the phone to 17%, unplugged it for 2m 27%, now at sub 9% battery..
Android - 56%
Cell - 20%
Display - 17%
Phone Idle - 7%
Right now this phone is as useful as a brick, i've uninstalled the weather app and a bunch of other 3rd party things that I thought could have been causing it, but this is the second time now.. My battery life sans being plugged in is around 2 hours tops, with or without using the phone.
Under battery usage the android system is usually over 60%.
Should I do a full reset and if so how do I go about doing that?
Like the the post says my wireless tether no longer works( at leat not fast ) with any of my 2.2 nandroid backup I have all the wireless thether downloads ( the 2.0.2 and all the 2.0.5 versions ) and they just stoped transfering or transfer really slow. By slow I mean it will take anywhere from 30 seconds to a minute sometimes longer for a page to load. This is the case with all my 2.2 roms Damage Control 3.5, Baked Snack 1.0 and 1.5, Fresh 3.something and even my stock 2.2 rooted rom. This is the case with any kernel and I have been using various Kings, (but tend to stick with Netarchy's kernels) All with the same problem. Everything else works flawlessly.
This wouldnt be a big deal except I use wireless tether everyday for homework so it is a must have for me. I had to use the tether feature on my wifes Palm Pre (you know how that made me feel) I have her phone overclocked to 800mhz and it felt as if her battery was going to melt or explode, which usuall happens if you use it for too long. I had to get an Ice pack and put a towel on it to keep the phone cool while tethering.
I even tried it with flashing new room and kernel and the only app being all the versions of the wireless tether. That still was a no/go.
I however did find a solution but not a good one. I had a nandroid back up of a HTC 2.1 stock rooted rom with Nand unlocked and with the FPS un capped. This however when I look for wireless networks to connect to on my computer, it shows up as 3computer connected together instead of the 5 escalating bars like in the att comercials (dont ban me for that)
but it works perfectly and lightning fast. The version I'm usuing is the 2.0.2 version not any of the 2.0.5 versions.
I know this is a bit drawn out but can anyone explain why this happened? I mean it worked one night and the next it didnt. Or can someone can someone explain why it works on 2.1 and not on 2.2?
I miss some of my 2.2 feature but there are none that I can't live without but I would like to be on the latest software version.
I'm trying to schedule my alarm manager to fire up an intent every hour in a day. this is what I do , and it doesnt work properly.
code:
new code after edit:
CODE:.................
Ive had my moment for approx. 9 months now and I have taken very good care of it, never dropped it and ive had a case and screen protector on it the whole time and now i am losing my touchscreen. on the top right of the screen when you touch it it either doesnt do anything or it will think that i touched something on the left upper side. so you all know where im talking about when you pull down the notifications bar and you hit the clear button it doesnt work at all. is this phone just done or can it be fixed? anybody else have this problem? I just don't understand i took so good care of this phone!
View 2 Replies View RelatedMy touch screen stopped working whe I tried to load a custom rom on it. Are there any ideas i can try to fix it? Ive even tried wiping it back to factory settings.
View 1 Replies View RelatedThe UK HTC TV adverts show a Desire, and the tag that you can simply flip your phone to silence it.
View 7 Replies View RelatedIs it me, or is there something completely wrong with the Search feature on the calendar of the Droid? I have an Incredible, recently upgraded to 2.2, and when I use the search feature to look for something in my calendar, it says that it is not found, even though i can go to the day I am looking for and the appt is in there!
View 6 Replies View RelatedOkay so all of a sudden yesterday the lock button on my Samsung Moment kind of stopped working. When you press the hang up button on the phone, its supposed to lock. If you hold the hang up button it brings up a menu for power off, sounds off and airplane mode.
For some reason when I press the hang up button to lock the phone, it doesnt work but when I press and hold the hang up button, the menu thats supposed to pop up does.
If the button semi works I cant see it being a problem with the button. My friend says its a software glitch but it worked fine for months and then all of a sudden yesterday morning it stopped working. I HAVE NOT updated the phone or anything recently.
Haven't got my update yet to try and was just curious.
View 2 Replies View RelatedI updated my Evo to 2.2 when it came out, but I just noticed something about flash in the browser: I cannot interact with any of the buttons. For example, when browsing the youtube full site in the browser (not the youtube app) you can hit the button to turn on captions, and hit the other button to switch to HD resolution. For some reason, I cant figure out how to hit those buttons. I tried zooming in all the way, and I hit the resolution button, and the resolutions popped up for about .5 of a second, then went away, its too quick to hit it. I tried double tapping the flash to make it full screen and that doesnt work either. The only thing I can get to work is the slider bar, which seems to work fine.
View 4 Replies View RelatedSo for my Eris i flashed the new kayos v38 rom and add the conap cfs v8 for the camera and battery drain fix.
Now heres a new problem that I notice! The vibrate for the incoming phone doesnt work It worked last time a install the exact same thing. but now it's like total silence when i put my phone on vibrate.
Is there a way to get rid of the loud "bling" on the Telstra start up screen?I got "silent boot" from the App store, , but it doesn't work.I dont want to have to put the phone to silent every time I turn it off.
View 3 Replies View RelatedMy Windows 7 laptop seems to find the barnical network, but when I connect it doesn't seem to work.
View 3 Replies View RelatedMy WiFi tether app doesn't work with my Frankenrom why?
View 6 Replies View RelatedIt seems as if my phone doesnt saying 3G it just shows bars doesnt even show 1X. Im wondering if there is a setting im missing or do i need to reset/update something.
View 4 Replies View RelatedI read that we will be getting wireless n option soon which might also mean a froyo update as well. this is the new manual from the fcc, check the specs page at the end:
https://fjallfoss.fcc.gov/prod/oet/forms/blobs/retrieve.cgi?attachment_id=1298744&native_or_pdf=p df