Can anyone tell me whats the best settings for a newly rooted fascinate using setcpu? When I install it its set to min on both sliders. Not sure where I should start with it. Also I dont have any voodoo kernals loaded (yet) So I just want to get it set up to start playing around.
View 1 Replies
This is the first time I've rooted a phone, and i picked the Kaos Froyo V38 as the rom, but I've noticed since i did all of this my battery has been far far worse than what it was un-rooted. Today, for example i had my phone off the charger and on vibrate (with gps, mobile network off) and i was down to under 15% in under 5 hours. This is so much worse. Is it because i'm now running 2.2? What can i do to help this besides wiping the battery data (in the recovery menu)? I'm not really good with all of this yet, so some suggestions would be wonderful.
View 7 Replies View RelatedRooted my Vibrant pretty much as soon as I got it, installed SETCPU and while it did make my phone MUCH more responsive it was also causing problems.
I asked for help on XDA but most gave pretty vague answers, so I eventually ended up uninstalling it....
Well, anyhow, I found this really helpful post and now I am going to give SETCPU another shot. So if anyone else out there is having issues read this:
OverClocking 101 - Droid Forum - Verizon Droid & the Motorola Droid Forum
Is there any settings or apps that will allow SF to return to the home screen when you turn on the phone again? It would be nice not to have to hit the home button each time I turn the phone back on?
View 5 Replies View RelatedEVRC-B allows you to have enhanced voice quality in large metro areas. On the HTC's, you could dial ##PROGRAM, press send, choose EVRC-B and BAM! It made a huge difference for us city folk.ny ideas?
View 4 Replies View RelatedCan someone explain kernals? I recently rooted my phone and am running froyo, but I am still in the dark on what kernals are...
View 7 Replies View RelatedI am not tech savy at all and I just pulled this off! I rooted and installed Fresh 2.3.3. I've read that you need to change the "kernel" but dont how to do this. I found this thread [KERNEL][7/22/10]Darchstar's Overclocked Undervolted kernel for senseUI roms vUV 2 - xda-developers but its not making sense either. Also read about SetCPU to increase speed. Can someone please post up links and explanations?
View 11 Replies View RelatedThis unit's radios worked reasonably well until rooted. Now, only 10' from the wireless router, it's intermittent. Phone and Bluetooth are both ok Our two laptops and the wireless printer have no problems. Everything else about this newly-rooted phone is terrific. What could I have done that degraded the WiFi radio? What can I do to get WiFi back?
View 4 Replies View RelatedSo Im running stock rooted frg22 and was wondering if I could put overclocked kernals like slayers or something over it because I want to overclock and am satisfied with the stock froyo rom.
View 8 Replies View RelatedI don't want to mess up the phone by my mistake.
Are there app that i can do this? simple and easy.
I recently rooted my EVO (Tonight!) I downloaded SetCPU so the processor will run faster when its awake and slower when its not. I can't for the life of me seem to figure out how the heck to get it to overclock. I don't see the word anywhere in the app, and the slide bar only goes up to 998 mhz (my Evo's max?) Is it in the other menu settings I don't quite get?
View 6 Replies View RelatedIs there any way to do this? It is annoying to have to set the EQ settings everytime I go to the music player. Why does it not retain the last settings used after you quit the application and then go back to it?
View 3 Replies View RelatedA few friends of mine purchased the Fascinate after I got one. I've been supporting their and try to keep them loaded up with all the same customizations that I use. I am wondering if there is a way to export my settings (like saving with Clockwork) but having all of my personal information wiped from the build. Is this possible? How do people create the images we typically download? Would love to be able to load up all the free apps I use and have them be pre-installed if I flash a friends phone.
View 2 Replies View RelatedI just rooted my phone. I'm not new to rooting either. And when I was pulling up a file, I got this screen. Another interesting thing, is that we have a file called FlashSVGPlayer.apk embedded into the phone, and FlashPlugin.apk
Update:
FlashPlugin.apk is Pineone Flashlite Plugin.
but FlashSVGPlayer.apk is Adobe Flash Player.
I rooted my phone and applied the lag fix all went well until I tried to change the wallpaper from the live water to one of my daughter. It doesnt matter what picture I do and now even if I pick a wallpaper from the wallpaper gallery they all change to the wallpaper of the sunset with the water and rocks... Even using launcher pro it acts weird I have to change what wallpaper I want using touchwiz switch to launcher pro reset it for it to show a wallpaper I want. This all seems a little odd and was wondering if anyone else has had a problem similar.
View 7 Replies View RelatedAnyone foresee any issues on OC'ing on the standard rooted ESE81? Does the kernel support overclocking?
View 7 Replies View RelatedI just rooted my new Evo and installed SetCPU, i set up some profiles for when my battery reachs like <25 and i was testing this out at like <75 and noticed that even though the notification shows up as the profile is active, in systempanel app and also even in SetCPU is still shows the cpu reaching core speed of 998 instead of the speed it should be capped at...
So my question is, is setcpu actually working?
The Sampling Rate, Threshold, etc. What do they mean and what are some optimal settings? I have mine untouched from whatever was stock with the app. Just curious if these settings were worth messing with unless you were advanced user, much like the settings themselves.
View 1 Replies View RelatedI rooted and downloaded app can not get to connect to laptop. Do I need to turn the wifi on my SF too?
View 45 Replies View RelatedI want to state that I LOVE my phone and it perfectly does everything I need it for. I just have a minor problem. With all the tweaks I've done (and redone) I can't for the life of me get my phone to last more then 8 (or less) hours.
Here is my phone settings.
I'm rooted via the new root method (ota simple) from xda. It worked flawlessly and then I installed the dmg rom on the Battery Saver method. Got a little bit of time. THEN I purchased and followed the SetCPU program tweaks and did that to the T. I also have the following: GPS On. Mobile Internet on (no wifi or bluetooth).
I have all "Friends" syncing off but I have my gmail and work email on push (required via my job)
I have my brightness set to almost the lowest and I have to charge my phone about 2pm everyday otherwise my phone is dead.
Typical day: Wake up at 7am unplug phone. Check email/comics then go to work. I'm an IT sys admin and am required to have my phone/answer emails throughout the day. but at least 4 hours the phone is just sitting there or I'm lightly texting on it. But no matter how little or how often I use it it gets about 30% dead about 2pm with ALL the tweaks i've done.
This might make all the difference. I have LOW signal at work and home (1 little bitty bar to none). And my cell standby is almost always above 50%. But with all the tweaks (yes I've done the network app and yes its on CDMA) with PRL and profile updates (rooted and unrooted) it still has the problem.
With SetCPU? It does not save settings across reboots, so I have to go into it everytime and read just the sliders, even with "Set on boot" checked.
View 6 Replies View RelatedLoved the app for the G1, since it was capped and setcpu got it to run at max speed. Ditto for Droid, since it was also capped and the OMAP had plenty of ceiling for more speed.The Snapdragon is already designed to dynamically scale from 245mhz to 1ghz, so what good are the settings, if Snap is already detecting resource needs and adjusting clock accordingly? This function is built into the die and seems no need for software augmentation.I appreciate insight, since some of the posts I have been seeing may suggest something that Snap already was designed to do and is built into the hardware.all of the needed polling that must happen through software for profile conditions may offset any gain as well. Seems inefficient managing via software, when the chipset already dynamically manages- unless Snap does a poor job in the first place.
View 5 Replies View RelatedI just rooted today and downloaded Bugless Beast V1.0 ROM as well as the kernel that allows for overclocking up to 1Ghz. I'm playing around with SetCPU and wondering if anyone has any suggestions for the min/max settings within the profile. I don't want to fry my phone, so if there's someone with experience with a kernel with similar capabilities who would be so kind as to share his profile settings.
View 3 Replies View RelatedI have tried several different Froyo Roms over the past very weeks. I still can't get any good battery life out of them compaired to running EE3.0. Yet everyone tells me they get better battery life while running Froyo. My phone has currently been unplugged for 9hrs 13 mins. It has a total of 50 mins talk time and I have sent 30+ text messages. My battery level is @ %73 running EE3.0
I can't get a total of 11hrs out of my phone when running any of the Froyo Roms. Ive tried running several different settings on SetCPU but nothing noticable. Only thing I notice is that when running Froyo the largest use of my battery is my Display. Yet when running EE3.0 the largest use is Cell Standby and Display is the lowest. But I have tried turning the brightness almost all the way down on the Froyo ROM but it doesn't make any difference.
I'm running a rooted Eris on nonsensikal 3.9. I just rooted last night and I'm very new to all this. When I first ran setcpu it gave me another root access error. So I went onto super controls and gave I access. Now whenever I run setcpu I'm. Able to move the slider only one time then it freezes everything so bad I have to pull battery.
View 32 Replies View RelatedI had my phone rooted and now cannot find my Account and Sync Settings.
When I check system / app and the apk is no longer there. Tried to add another account & sync apk apk in but still no account & sync settings show up.
Also noticed that there is no odex files only apk files under the system / app folder.
Phone is Hisense e910 using android 2.3.6
Got setCPU. What should I do now? I used the SMUpdater. Is there any way to change the color of the status bar?
View 8 Replies View RelatedI have now been using the overclocking function for over a month and would like to report on the settings found to be most effective.
I use a combination of apps to achieve excellent battery consumption (1 1/2 days generally).
1. Screebl, set to 15 seconds.
2. Milestone Overclock, set to custom 1000 MHz @ 69 vsel
3. SetCPU general 1000/500 with charge 250/1000 and sleep 250/500
Ive found that the 125 MHz setting does not push enough juice to the radios and i sometimes get glitches with the touch panel/ dialler when SetCPUs ondemand governor is waking up to a call or 3g connection.
Also, the lowered vsel value of 69 seems to save a half day's battery as opposed to standard 1000 MHz/ 72 vsel offered by Milestone Overclock.
Screebl is a must for anyone who doesnt have it, as its simply the most effective battery manager out there. Would like a five seconds option though
You will need to flash an extra file, but you can now run your rooted hero at 528 (or slower if you prefer)
ITS SO GOOD
[CDMA KERNEL ROM]Gumbo Kernel beta project + RAM hack - xda-developers
I didn't have anything to do with this, and I didn't find this link, I just posted it from my old thread about the overclock widget (thanks to whoever found this). I figured that people who don't check xda regularly (like myself) might want a heads up, so here you go.
All I hope Samsung will no do what they did to the Behold II. They said they would update Android 1.5 to 2.0. They backed out and said they will only upgrade to 1.6 or 1.7.
View 14 Replies View Related