KitKat 4.4 :: Stuck At Boot Logo After Failed ROM Install
Feb 17, 2014
I should have just left it as it was out of the box..So after attempting to install a custom rom (4.4.2 Play edition)my s4 is stuck at the Samsung I9505 boot screen. I wiped the 'Dalvik cache' 'System' and 'cache' partitions in TWRP as I was following along with a Youtube video (that didn't work). When I tried to flash the custom ROM it automatically said failed. After giving up and turning on the phone I found that I'm stuck at this screen.
Have I bricked the phone? $550 could have gone down the drain just like that. I don't want to touch it without any advice and make everything worse. My only hope now is that I've managed to wipe the original software and it has nothing to boot from.
Why did the ROM install fail in the first place? I had it copied on the SD card. It was zip file.I can still access TWRP just fine and my SD shows up with the custom ROM still there, it's just whenever I hit install it fails in under a second.
My Sharp FX (ADS1) is stuck at the "Sharp" logo when I try turning it on, now I know that are several of these post on this forum, but I still can't find any that offers a solution for me. The phone is rooted and that's it, I haven't had time to put a new ROM or anything yet (although I would love to) and I can't seem to get into any type of recovery mode, and I think I have tried all of the button combinations, the only time that I can get it to show something other than "sharp" is when I plug it in, it shows a charging battery.
I am using a rooted verizon LG G2. I rooted the device with ioroot 25 and installed TWRP 184.108.40.206 using AutoRec. (AutoRec - KitKat Recovery Installer - xda-developers, Here's a forum if you're unfamiliar with AutoRec)
Whenever I try to flash Cyanogenmod 11, TWRP says the flash is successful. I then go to reboot the device and I'm stuck in a boot loop of LG's logo. During the flash, TWRP mentioned that no MD5 file was found, which may or may not be related to the issue I'm having. During the bootloop, I booted back into recovery using the keys on the back of the phone and restored Stock LG KitKat. I've tried using multiple versions of CM 11, nightlies and snapshots. I'm stuck using TWRP 220.127.116.11 because AutoRec is one of the only methods I've had success with when installing a custom recovery.
yesterday, I flashed Modaco Switch for HTC One when my battery is low (20%). Now it wont let me pass the "HTC quietly brilliant" screen. I've searched the solution for hours and still, no luck on finding it out. But I see some thread that suggest me to download a new rom and put it in my SD Card, but I cant even pass the HTC boot up screen. Btw, I've relocked and unrooted my device.
I Have Xolo A500s android 4.2, Ram 512mb, GPU Mali400mp, 4Inch. i m gaming boy so for playing 3d n hd games in this phone i root it after root i install chainfire 3d pro n open click install tap and phone going restart phone ok after that Phone Is stuck Xolo Logo. And nothing happen In restor/format set boot setting.
I have samsung galaxy nexus and today i tried to flash a rom and the device stuck to the boot logo. The volume rocker doesn't work to go to fastboot mode or recovery mode and the adb device is anauthorized.
I bought a Galaxy s Duos S7562 and i installed rom cosmic V1.It was working .But after that, i find out about pmp ultra light rom.I tried to install it but it remains stuck at boot logo, I mean it is restarting at infinite.I tried a lot of basebands, kernels but the same thing happened.Now i tried to install Cosmic rom V2 and before that, I installed Fat.bin with ODin 3.04 but the problem persists.I used the baseband :Bmj1 ; Amd; Bmd but with no ressult
My device details: SGS3 T999, rooted, running Jellybean 4.3 on a liquid smooth ROM. Its a year old and has been a solid performer up until now.
My device is stuck in a cycle where it gives a quick vibrate, then SGS3 splash screen with white letters, then black screen, then tiny blue "Recovery booting..." words in upper left of screen, then black screen with couple vibrations, and around and around it goes in the same repeating cycle.
Just before it started I had taken the following actions: Dumped the following 2 files onto my EXTSD card (cm-11-20131217-NIGHTLY-d2tmo.zip, gapps-kk-20131119.zip) from my PC, booted phone into recovery mode using TWRP, did a factory reset wipe (success), cache wipe (success), dalvik cache wipe (success), flashed the NIGHTLY file (failed), flashed the gapps file (failed). At this point I should have sought some support. Fool! I next did a reboot step still in recovery mode. Without the reboot happening a message came up stating Superuser permission had been broken (the best I can remember) and the option to have TWRP repair the permission. I opted "yes" to repair. Then the loop started that I can't escape.
I have pulled the battery multiple times, tried a regular boot up, tried a recovery boot up (up volume+power+home) dropping the home button after a few seconds. Nothing is working. Prior to the above steps I backed up everything on the device. So I have backups to use if it can be done. My best guess is that I failed to update my CyanogenMod or TWRP to the very latest versions and it caused this hang up.
i installed jellyblast on my galaxy ace gt-s5830i, used it for couple of days and then restored cwm backup to stock rom. after about a week the phoen booted itself and got into bootloop. when i tried to wipe data got this mesaage : E:format_volume: rfs format failed on /dev/stl11.
* i tried installing cwm backup * i tried installing stock rom from samfirmware using odin with/without pit. * i tried multiformatter for changing ext4 to rfs and then again tried unstalling stock rom and also custom roms. * i tried wipe firmware package.
* phone enters in bootloop when i flash stock rom using odin and get stuck on boot when i install custom rom through cwm.
I've rooted my Desire on o2 have version 0.80 of the boot loader. I applied the defrost rom version 2.7 following this guide. Droid Den - Phone Guide: How To Install Rooted Android 2.2 On Your HTC Desire - Droid Den. It went through applying the ROM but now I just have it stuck on the o2 splash screen and going no further. Can't seem to find a backup.zip anywhere on my ROM and thought to back out the change. What's the best way to go? Re-flash again?
I'm not sure if this is considered a boot loop but when turned on, after the logo it turns into a blank screen.
Anyway, I was stupid enough to install 3D chainfire when it's not compatible (I neglected the description since it worked on my previous galaxy ace) ...
I've tried going to recovery mode to: - wipe data/factory reset - wipe cache partition (but shows error)
Not sure what else can I do anymore. Since Ace 3 is fairly new, it's quite hard to find a solution with google.. Also, I have zero knowledge about flashing ROM or of the sort..
Extra info: - My phone is Samsung Galaxy Ace 3 GT - S7275R - Rooted with a Chinese universal rooting program - When entering recovery mode, it shows "no command" for a few seconds before entering the menu.
I was on 2.2 rooted on my droid x. Attempted to install a replacement for the taskbar. The phone is stuck in a boot loop now. I've read about 5,000 different pages saying just use RSD. It all starts by saying; plug the phone in, let the computer detect it, install the drivers.. This is where I'm stuck. The only thing I have access to is the recovery console and the big endless loop. So at no point the phone turns on to the point where the PC will detect it as a device.
Instead of seeing the boring old Android logo or my service provider's logo, I'd love to see the standard text-based Linux boot screen that shows the status of all the hardware and configuration info as my phone boots. My current phone is an HTC EVO 3D running Cool ICS with Sense 3.6 and Revolutionary CWM.
I tried installing Tranquility and must have screwed something up because now my phone won't boot past the Motorola Logo. It's been sitting here like this for about 15min and I can't even boot into recovery by holding the power and home buttons. I don't know what else to do now. Idk if my phone is bricked but even if it is don't I need the SBF file to unbrick it and I can't find that file any where. I did a nand backup or whatever before doing any of this so hopefully that can help me. What should I do now?
i was running the latest version of Slim Kat rom for my i9100 when it turned off and then was stuck on samsumg boot logo. When i try to access twrp it just says teamwin and wont go any further. It happened once before and so i just flashed a stock rom and then went back to rooting it. However, now when i try to flash any rom (stock/custom), or another recovery with odin it freezes at "nand write start". I have access to download mode which is really the only thing i have working atm
Ive read around and done everything (eg try other usb ports/cables/odin version) but no luck. Is there anything else i could do? I dont wanna do a pit flash cause im scared ill completely screw it up.
I try to backup my stock ROM using clockworkmod Recovery through my optimus hub. when reboot my phone entered into "fastboot mode started udc start() " . then I try to install cwm recovery partition using fastboot.exe. but now I got stuck at LG logo screen and nothing is working.
So, I'm attempting to create a custom bootscreen for my EVO, and was trying to find out if anyone knew how to get a copy of the initial "htc EVO" logo with white background that comes up?I've gone through the file system a few times, but haven't managed to find anything in there.Is it hard coded into the phone itself somewhere magically?
aright so i found some other threads with my problem, but no answer really i dont think. but anyways. so im running 2.3.9, flyx and tranq. when i shut my phone off and back on sometimes it gets stuck at the motorola logo, i do a battery pull and its fine. but its just annoying cause i forget sometimes and it stays on it for a few hours. is there any fix for this.
I was messing around with clockwordmod recovery and did something I shouldn't have. I am not deodexed, but I heard that you could apply some of the rom modifications without any problems. So I did one, and it was ok. I decided to try a different one and thats when I ran into a problem. My phone is stuck at the M logo now and I am not sure how to fix it. I could have sworn that i made a recovery before I installed the .zip but when i went in to try to recover it said there was nothing there. My one savior is that I have the SBF file I need, but I am on a mac so I can not use at the moment and would like to avoid this at all costs. Does anyone have any suggestions for me or will I need to SBF? Also, i have not let it sit at the M logo for an extremely long period of time, is it possible that it will pull around and start to load properly or is there definitely a problem?
I was rebooting my phone today and it every time I try it gets stuck on The Galaxy S logo with the big flashing "S" on the screen. It acts like it is going to boot up but just after the ATT screen and the boot sound it gets stuck. I did the one-click-lag-fix about 2 weeks ago and the phone has been running smooth ever since. My wife and daughter are on the road so not having a phone really stinks right now.
I just finished updating my wifes Droid X to 2.2 (rooted) moved SU etc.. the phone boots completely (I can ADB in and it makes noise) however it only shows the M logo. I cant boot into recovery and the only way to make it boot is to adb reboot-bootloader anyone know WTF is going on here? I've never seen anything like this before!
I rooted my X so I could take screenshots. I saw all the hoopla over the new froyo release, and figured I'd try it. Well, now I'm bricked or stuck in endless boot, whichever, and can't get past the Motorola Logo. What can I do? I plug my phone into my pc and it doesnt even recognize it. I keep seeing people telling others to flash the .sbf, but I don't even know what that means.