i am using sense 2.2 rom on my rooted htc hero with no problems on my 16gb microsdhc card. however when i used a kingston 32gb microsdhc i just purchased i can't seem to get it to work. i have formatted the sd card on my computer then i partitioned the card the same way i did with my 16gb card, then i partitioned ext2 to ext3 but when i restarted my phone with the 32gb card inside the screen was stuck on the htc logo. can anybody help please?
I have Alcatel One Touch Idol 6030x and I'm stuck at logo, I can't do anything with my phone except enter the hard reset mod ( which unfortunately does not solve my problem). what ROM,Flash,or anything like that is, I just want my phone to be functioning again as I really can't afford a new one.
My Sharp FX (ADS1) is stuck at the "Sharp" logo when I try turning it on, now I know that are several of these post on this forum, but I still can't find any that offers a solution for me. The phone is rooted and that's it, I haven't had time to put a new ROM or anything yet (although I would love to) and I can't seem to get into any type of recovery mode, and I think I have tried all of the button combinations, the only time that I can get it to show something other than "sharp" is when I plug it in, it shows a charging battery.
I should have just left it as it was out of the box..So after attempting to install a custom rom (4.4.2 Play edition)my s4 is stuck at the Samsung I9505 boot screen. I wiped the 'Dalvik cache' 'System' and 'cache' partitions in TWRP as I was following along with a Youtube video (that didn't work). When I tried to flash the custom ROM it automatically said failed. After giving up and turning on the phone I found that I'm stuck at this screen.
Have I bricked the phone? $550 could have gone down the drain just like that. I don't want to touch it without any advice and make everything worse. My only hope now is that I've managed to wipe the original software and it has nothing to boot from.
Why did the ROM install fail in the first place? I had it copied on the SD card. It was zip file.I can still access TWRP just fine and my SD shows up with the custom ROM still there, it's just whenever I hit install it fails in under a second.
yesterday, I flashed Modaco Switch for HTC One when my battery is low (20%). Now it wont let me pass the "HTC quietly brilliant" screen. I've searched the solution for hours and still, no luck on finding it out. But I see some thread that suggest me to download a new rom and put it in my SD Card, but I cant even pass the HTC boot up screen. Btw, I've relocked and unrooted my device.
I Have Xolo A500s android 4.2, Ram 512mb, GPU Mali400mp, 4Inch. i m gaming boy so for playing 3d n hd games in this phone i root it after root i install chainfire 3d pro n open click install tap and phone going restart phone ok after that Phone Is stuck Xolo Logo. And nothing happen In restor/format set boot setting.
I have samsung galaxy nexus and today i tried to flash a rom and the device stuck to the boot logo. The volume rocker doesn't work to go to fastboot mode or recovery mode and the adb device is anauthorized.
I bought a Galaxy s Duos S7562 and i installed rom cosmic V1.It was working .But after that, i find out about pmp ultra light rom.I tried to install it but it remains stuck at boot logo, I mean it is restarting at infinite.I tried a lot of basebands, kernels but the same thing happened.Now i tried to install Cosmic rom V2 and before that, I installed Fat.bin with ODin 3.04 but the problem persists.I used the baseband :Bmj1 ; Amd; Bmd but with no ressult
Instead of seeing the boring old Android logo or my service provider's logo, I'd love to see the standard text-based Linux boot screen that shows the status of all the hardware and configuration info as my phone boots. My current phone is an HTC EVO 3D running Cool ICS with Sense 3.6 and Revolutionary CWM.
My karbonn A1+ stucked on Logo screen.i tried to hard reset by pressing the volume down key and power button but nothing comes up then i put the set on charger the phone gets on but again stucked on logo screen..do i need to reflash but how do i ? the phone is not getting on recovery mode. isn't there a way to attach the mobile too pc and then reflash?
I have htc one 801e asia stuck on htc logo i tried to push zip rom in all way but cant make it work i search a lot for ruu but cant find. give me a linke to download the official ruu exe for htc one 801e
i tried to upgrade android ics 4.0.4 to jb 4.1.2 (cm 10), the installation went well,but when i tried to reboot i got stuck on the logo screen for a few seconds and then it turned off.i tried for a few times and it's always the same..
I was messing around with the camera and suddenly it goes to the White Screen with the Motorola logo in the middle. Its just stuck there. I've pulled the battery for at least 30 minutes, tried holding down, up, camera, while turning the phone on, no luck. Every time I power it up its just the same white screen. It's doing nothing. Are there any other manual methods of resetting this thing?
I have a rooted eris running "Eris_Official_0.8.1T2" rom. I have seen threads about how to change the boot logo/animation, but no one knows how to remove the animation entirely. I would like the verbose boot to display on start up if possible. Has anyone done this? I have seen something similar with the android on iphone(at 1:53 in the video)
Recently I flashed to this ROM [URL] .... from a stock ROM. Have done it a few times before and no problems have occurred. It's an MIUI rom and I decided to customize the theme a little. The themes section allows to change most of the detail ie fonts, status bar, home screen, lock screen, icons, boot animation.
And that's where it started, when I changed the boot animation, instead of using the default one. When I did a reboot after the switch, the usual boot logo was up, but then the screen turned pixelated like a CRT monitor/damaged LCD screen with colourful pixels. But then in boot into the new animation all fine, and has been ok since. The device boots fine, but I'm worried about that pixelated screen.
I can root a g1 with ease but I sort of got into trouble with the behold. This might sound stupid but do I need to root the phone before I install the port galaxy 1.6? I just did this.
1. download odin here Odin Multi Downloader v4.03.exe 2. download any Of BH_MAN ODIN Ready Rom's 3. download winrar ( google it) to extract the BH_MAN zip file. 4. follow these instruction
Quote: 1. Unzip the zip file. 2. Open Up ODIN Multi Downloader 3. Click the OPS button and choose Behold2_partition.ops 4. Click the PDA button and choose the md5 file, You will get error message" invalid image...," but ignore it. 5. Turn off Phone. 6. Plug phone into USB. 7. Put phone in download mode (Vol Down + OK + END Button) 8. Wait till detected and press START. 9. Enjoy the Port.
And my phone was stuck on the android logo. do I need to root first and where can I find this? Is this where I go. http://androidforums.com/all-things-root-behold-2/22470-persistant-root.html Can I do this method even though my phone is stuck on the android screen? How can I get back to default at least?
1) Samsung logo stuck screen 2) Recovery will only work when plugged with a usb cable to my computer 3) Did factory reset/wipe data cache/everything still samsung logo stuck 4) Kies 2.0 wont recognize the phone i think it has something to do with battery charger option turned on when you plug it with a usb(i remember from a thread someone said if you have it to charge when you plug it to your pc it wont work)
So is there any way i can still make my phone back to work?I tried with the pull battery off charge it and not working..Is the kies problem because of a bad usb cable?should i get another one?I was running officcial rom no custom rom just rooted the device