I just plugged in my HTC Incredible this morning because it was dead and it went to a black screen with a big triangle with an exclamation point. I tried holding down my lock button, nothing happened. I have nothing backed up, so it would be nice not to have to hard reset.
i have sony ericsson LT29i replica, i got error too many pattern attempts, unable to access internet from handset now i want to reset hard it by pressing volume down + power on, but i am getting just only Yellow triangle with exclamation mark on screen.
I got HTC flyer 3G from my friend as gift....that one was rooted and s-off .when i tried to flash custom rom it showed option like recovery,wipe/factory reset,.
After 2 days,I have installed AVAST Anti theft app and forgot the password for it...so i gave it to reinstall the OS...and it was back to normal...So I thought to put custom rom..and started to boot the device with SD card inside....BUT the recovery didnt show any options as it was shown earlier,the black screen appears with triangle mark with '!' symbol....
The screen shows the following message
FLYER PVT SHIP S-OFF L HBOOT- 6.10.1002 MICROP-0850 RADIO-3809.04.04.2LM eMMC-boot may 4 2011
I don't have a rooted phone. I've been running the IK5 firmware for a while with no problems. I had to travel to the states and put my phone on airplane mode and then decided to shut it off. When I tried to turn it on, it would get to the Samsung "glowing" logo and stay there for awhile. Then the screen would flash and the Samsung logo would appear again. My phone was stuck in a loop after that. It never booted up. I decided to try and reload the firmware and that didn't help. Then I tried recovery mode. That's when I got the infamous triangle with and exclamation point in it. After that nothing. I guess I may have somehow bricked an unrooted phone. Although this isn't my specialty.
I was trying to install the latest software via software companion and it was taking well over an hour. So I removed the phone to complete it later. Big mistake. My phone is now disabled and only shows an exclamation mark and triangle. What I have to do to restore it.
Trying to reboot into recovery, and I get up to the point of my screen going white, saying htc EVO, and instead of recovery, I get a black screen with a picture of an evo, and an red triangle with an exclamation mark? what does this mean?
My phone works fine. Aside from rooting troubles, it boots up perfectly. Im on hboot 1.47 and want to root so I've been experimenting with it. ANyways, I boot into recovery mode, and all that came up was a picture of an eris with a red exclamation mark on it. What does this mean?
I rooted my DINC a while back using Unrevoked 3. When 2.2 became available via OTA, I kept refusing the update, because I wasn't sure if I could update to it from a rooted phone. My wife was using the phone one day when the update notice popped up again, and she proceeded with the update. Sure enough, the update ended up failing, with a red triangle and exclamation point.
After I rebooted the device, I never received another OTA update request. So I tried to unroot the phone, but clockwork seems to stick around. Just an hour ago, I tried to install the official 2.2 ROM (PB31IMG.zip). After applying the image, I get a green triangle, then the same red triangle with an exclamation point. I restarted the device, but now it boots into the white hboot screen, with the following info:
I did the simple root last night and installed the latest version of damage control that rom manager had access to. So after I loaded it onto my phone I tried to run DCupdater. The update downloaded fine, but I found that after it tried installing I would run into a screen that showed a yellow triangle with an exclamation point sign in it with an android next to it. What can I do so that I can update DC?
OK, I used Soup or Root to root the phone. I see that i have root access. I installed Rom Manager. But no matter what rom I try to install, I get the little triangle with an exclamation point with the phone below it. I am sure I am missing something. Help a newbie out? So far I have tried to install bugless beast and cyanogenMod.
Android 2.2 (froyo) is updated for GallxyS 2 days ago. So I just try to make it updated on the webpage to play. whenever I did, it just stopped with play button? or exclamation mark. What I did is following.
In main activity, webview = new Webview(this); webview.loadUrl("file:///android_asset/flash.swf"); webview.getSettings().setPluginsEnagled(true); setCeontentView(webview); and XML file is nothing changed from startup. Did I something wrong for the flash player?
I'm having with my Matrix One tablet. I'm getting an exclamation mark inside of a triangle, inside of a battery icon. The issue started after I let the battery completely die out. I can't get past that screen. When pressing power the battery icon shows up and the tablet shuts down a second later. I tried all button combinations to get into recovery, nothing worked. I've also tried charging the tablet.
There was one thing I managed to do, that was get the tablet to show up on my computer. I held down the update button with a needle and then held the power button until a blue light indicating the tablet was on showed up. The screen was black but my computer detected a new device. My computer didn't find any drivers for the tablet, so I went in search of them myself and couldn't find any. My tablet is A10 compatible, but none of the A10 drivers I found seem to work on my tablet when I go to manually update it through device manager, neither does the PDAnet method I found online.
I was able to find a recovery that works on my device, one that will allow me to reset my tablet, if I'm able to boot into recovery after I get it on my tablet. Now in order to even test the other recovery I need drivers for my device so ADB can detect it and I can push the recovery. My device is already rooted with Superuser updated to the latest build.
I'll add that I've even taken the liberty of opening up the tablet to see if I can disconnect the battery from the board to cut all power, as I'm unable to do that because the batteries are connected by soldered red and black cables.
Sometimes when I reboot my phone, I first see the 3 androids on skateboards and then it goes to a pic of phone with the red exclamation point in a triangle (same as the failed recovery error). I can pull my battery but that does not help. My phone is useless for at least 30-45 minutes. I have pulled my battery up to 20 consecutive times to fix with no avail.
The variables: This is a refurb phone with 2.1 pre-installed. I have tried to root my phone with the whole timing trick, pull card, insert card. This was done a week or two ago. I do not have that file on my card, nor was my rooting successful. I am thinking that my problem is due to the refurb. My dialer lag is way worse than my previous phone. I can make one phone call every hour or so and I can forget calling someone right back if I missed their call. Does the red triangle/exclamation point show an attempt at rooting?
After I use SEUS to update my phone after I pass the Sony Ericsson I get an X10 picture with a yellow at exclamation mark, it doesnt do anything, what can I do, I tried running SEUS and PCCompanion but it says I have the latest software and it does NOT give me the option to fix the current.
It is two days now that my GS2 (stock 4.1.2, PhilZ latest kernel + some bloatware removal and little ROM integrations, like androidlost: nothing recent, anyway) after being turned off all night long, boots up to the home: it responds for half a minute than freezes for a minute or two; then soft-reboots and then go all ok.If I turn it off and on, I have no problems: this only happens at first boot in the morning.
I'm not sure, but it also seems that if I let it boot the first time without touching anything, after the screen goes black the autoreboot does not trigger.
I have an Allwinner A10 clone (Kurio 7), it is designed for kids but otherwise a standard android tablet. After hours of googling I rooted and installed CWM & Gapps (not included in the stock ROM). So far so good. The stock ROM was causing issues with some apps, it needed to go.
I flashed CM10 and it worked but no touch screen. It needed a compatibility flash to make it work. You can guess what's coming. I picked the wrong one and now the device does the following:
Reboot loop Black screen (backlight though) PWR+Vol up no longer gets to recovery Vibrates constantly between reboots (due to wrong patch I'm guessing)
ADB picks up the device for a split second between reboots but "adb reboot recovery" does nothing. Even when using wait command. Tried "fastboot flash recovery cwm.img" after wait command, no luck. Is there anything else I can try?
Is there a way to input the exclamation mark "!" When I'm using the Google pinyin ime on the milestone's hardware keyboard? In fact there shld be plenty of other symbols i cant find on the hardkeyboard, just that i havent realised it yet.
Currently any time i want to input the "!" I have to shut the hardkeyboard and go to the soft keyboard for the symbols menu and this feels semi-******ed...
This was reported in the other thread about X8 Issues, but thought to start a new one to gather feedback from users. It's about the ''black screen'' freezing issue encountered by some users. I have had this several times since owning the phone for a few weeks, so it is a recurring issue. Problem: The phone hangs or appears to be shut down or become unresponsive suddenly. Pressing the hardware buttons doesn't help as the phone doesn't react at all. Solution: Take out cover and battery and restart.Observations: From my own observations, it's not actually a shutdown but a major freezing/hanging. Sometimes when it happens, I can still see vague shades of the display at an angle. After leaving the phone for a while in the pocket, the phone comes back to normal again. Not sure if this is true for all users with this problem. Anyway, gathering more feedback to see how prevalent the problem is, to evaluate whether I should take it to the SE service centre, or whether doing so will help at all.
So I just finished my ota 2.2 update... since the install everything has been working great however when I open the camera (still or video) it will not open. The screen will turn black with the camera or video image and then go back to the home screen. I have tried restarting the phone with the same results. Any suggestions? Has anyone else experienced this? btw I was unrooted and stock if that makes a difference prior to the update.
My aunt gave me a Samsung Galaxy S2 and everything was fine, except that it didn't let me register to the network. The next day it told me that it had to do an update so I did the update. After the update the home screen turned black and pressing the buttons didn't do anything. After a while an error pops up saying "application is not responding" and then the screen just stays black. The top bar works just fine and I can even go on the internet, play games, practically do everything. I did a factory reset by pressing Volume up + Home + Power 3 times already, but the only thing that changed is that the language turned into German.. the screen stays black. It had nothing to do with Rooting or Flashing, because I don't even know what that is.